home *** CD-ROM | disk | FTP | other *** search
- SMCap
-
- Written By CMH Electronics
-
- March 1994
-
-
- Introduction
-
- SMCap is a small program that is intended to mimic some of the
- actions of Novell's capture. SMCap was designed to allow access to
- Novell's print spooling redirector. In particular, SMCap will more
- readily allow you to direct your printouts to the queue of your
- choice from within an application. Because SMCap is about 140KB
- smaller than capture, it has a better chance of being successfully
- executed from within a large program.
-
-
- Running SMCap
-
- To use SMCap enter
-
- SMCAP lpt# queuename
-
- from the command line. "lpt#" is the number of the printer port which
- you wish to redirect, and "queuename" is the name of the queue to
- which you wish to redirect it.
-
- Notes
-
- At this time the queue must be described in the bindery on the default
- server. There is no endcap facility; Novell's endcap is quite small.
- There is however an implicit endcap when you select a new queue. This
- program has been tested only on Novell 3.10 and 3.12.
-
-
- Shareware Concept
-
- SMCap is our first attempt to offer a program under the shareware
- concept. If you like this program and find it useful we request
- that you contribute to the development of this and similar programs
- by sending $5.00 to our address below.
-
- CMH ELECTRONICS
- 134 HILLCREST AVE NW
- NORTH CANTON, OH 44720
-
-
-
- Novell is a registered trademark of Novell, Inc.